X10/PLCBUS Transfer Interface

PLCBUS Security Interface Module

10A High-Duty Relay

30A 1-Phase Whole-House Filter

40A 1-Phase Whole-House Filter

30A 3-Phase Whole-House Filter

Crystal Panel Color Kit (8 colors)

* 1 Main address + 16 Scene addresses.
* Turn On/Turn Off control of Shutter motor.
* Conveniently, codes are electronically set and can be 　programmed in only 6 seconds.
* Ability to control from remote location through computer or 　telephone interface.
* No responds "All Lights On/All Units OFF" commands.
* Local ‘manual’ control with “Mechanical switch”.
* Built in noise filter.
* Compatible with any PLCBUS controller. For example: Mini-　controllers, Wireless series, Wall switch controllers, Telephone 　controllers, Computer controllers etc.

("Turn +" replaces "Turn positive aspect; and "Turn -" replaces "Turn reverse" below; The first responds action is opposite of last action ):

(1), Control by “Setup” button on in-line module:
When the motor is stop, tap “Setup” button, the shutter motor is "Turn +", tap again, the motor is "Turn -"; again will be stopped…

(2), Control by “One-button normal mechanical switch”:
A: If firstly tap "Top" button - "Turn +", "Bottom" is for "Stop"; Tap "Top" again - "Turn -", "Bottom" is for "Stop".
B: If firstly tap "Bottom" button - "Turn +", "Top" is for
"Stop"; Tap "Bottom" again - "Turn -", "Top" is for "Stop".

(3), Control by “Mini-Controller or Remotes”:
If “ON” Button is for "Turn +"; tap again during motor action, the shutter can be stopped;
“OFF” Button is for "Turn -"; tap again during motor action, the shutter can be stopped;
“Bright” and “Dim” buttons, one tap for 10cm moving. Note: The motor must has two limited fixing at  the two ends of track, thus the motor will be stopped automatically when it move to the end of track.

* Rating voltage               230V ±10% 50Hz

* Electromotor Power       ≤ 45W

* Device power usage      < 1W

* Suitable temperature     -10 to 50 degrees C